 |
 |
 |
 |
| When you unwrap your packages you should have the collection of parts shown here... |
First, jack up the rear of the car and support it securely on jack-stands... |
Next remove three fasteners under the edge of the trunk lid... |
Two more fasteners similar to the above... |
|
 |
 |
 |
 |
| Grab the front edge of the bumper cover and pull out... |
Your car will now look like this... |
Remove the bumper. There are five bolts holding it on. |
The plates go between the bumper and the car... |
|
 |
 |
 |
 |
| The plates and the bumper should now be installed... |
Now install the front mount... |
Put the hitch in place and install the pins to hold it... |
Reinstall the styrofoam, reinstall the bumper cover, and drop the car on the ground.... |
|
